We replaced our hot water tank 5 months ago and since then, in the room behind the closet where the tank is located, we can hear a “ping”. It is almost rhythmic. We have turned the power off on the tank thinking it was electrical but the noise continued for one hour. We have replaced the thermostat, which interestingly enough made a slight difference in that it generally stops during the night but as soon as water is turned on it starts again and will go for hours afterwards. I think it sounds like water dripping from one pipe onto another, my husband thinks I’m a worry wart! No water appears under the wall (we are on a slab). The noise is extremely faint in the closet where the tank is but can also be heard faintly in the other bathroom quite a distance away. Any suggestions? The manufacturer of the tank said it may be a “singing” element and to replace those with a better quality but if that was the case, it would be quiet when the power was off would it not? Please, any suggestions?

-Rae

Rae, it is possible for home water heaters to become noisy less than a year after they’ve been installed. And many times you can only hear the noises at night, when the inside of your home is quiet and there isn’t much going on outside.

In gas heaters, the noise can be caused by the buildup of lime, other minerals, or sand on the bottom of the water heater’s tank. When the heater’s gas burner comes on, the heated water bubbling through the mineral formations and sediment creates the noise. Electric heaters can generate singing or hissing noises, they have heating elements that are immersed in the tank’s water, and lime or scale accumulating on the elements causes the noises. The elements can be removed and cleaned with vinegar, but in really bad cases the element may need to be replaced.

You might be able to cut down the noise by disconnecting the heater and flushing the tank. But, it may not be possible to remove all the mineral deposits from the bottom of the tank, so that when you hook the tank back up, it may just become noisy again. If you have hard water, a solution might be for you to install a water softener, to prevent mineral build up.

-Brian

We have radiant heat (all copper tubing) in our floor. We have a leak in the system. Can your product be used to repair it? Also would your product affect the transmission of heat in the floor.

-Ryan

Ryan, epoxy lining technology is great for protecting a new system and can assist with repairing an older system with one or more small diameter leaks less than 1/8” in size. It’s not the cure all for all pipe leaks: the pipe must be metal; it must be structurally sound; and the leak must be from a pinhole, and not a crack, split or some other catastrophic failure. If the leak is too large, a repair must be made prior to the lining procedure. A certified CuraFlo professional can work with your system’s installer to determine the best way to make the repair(s).

Once in the pipes, the epoxy lining does provide some insulating properties (i.e. it will slow down the heat transfer), but this is not significant enough to interfere with the performance of your radiant heating system. The circulating hot water temperature of in-floor radiant heating systems are typically between 120° to 125° Fahrenheit (48.9° – 51.7° Celsius). Most epoxies are effective at these temperatures, and will allow your system to perform as designed.

-Brian